Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Fikret
—— Nadim
—— ngyum
—— Sanjay
—— tim
—— cagin
—— praveen
—— pawan
—— abbas
—— mohamed
—— Addy
—— MIN KEE KIM
—— adam phelan
—— Antonio C. Cuyegkeng
—— Andrzej Danielewicz
Process control plays an important role in dispensing process
The following process defects are easy to occur in the production: the size of the glue spot is not qualified, drawing, glue dip welding pad, curing strength is not good, easy to drop pieces.To solve these problems, we should study the technical parameters as a whole, so as to find a solution to the problem.
1. Size of dispensing
2. Dispensing pressure (back pressure)
3. Needle size
4. Distance between needle and PCB board
5. Glue temperature
6. The viscosity of glue
7. Curing temperature curve
8. Air bubbles
Factory Address:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
Sales office:HENGFENG INDUSTRIAL AREA,ZHOUSHI ROAD NO. 739,HEZHOU COMMUNITY,HANGCHENG STREET,BAOAN,SHENZHEN,CHINA | |
+0086-136-70197725 | |
linda@eton-mounter.com | |